You may clear up some room in your closet by creating a wall-mounted overcoat hanger with more hooks. Having the correct equipment and knowledge is required to make your next project a success. Make your coat hanger with the help of this article.

Cut the Wood to the Right Dimensions

The foundation of your coat rack should be made of wood. You can either utilize a leftover piece of board or buy a new one for the purpose. A minimum of 24 to 36 inches in length should be sufficient for typical installations, although you may need a longer or shorter length depending on your needs and the wall area.

Then handsaw the board to the size you wish. Use a piece of emery paper or a polishing scrub to polish the jagged edge and level it out.

Using a Power Drill, Make Hook Holes

Test holes for the hooks’ fasteners should be drilled. Hooks should be attached to the panel using equidistant intervals determined by a measuring tape. The length of your final rack should also dictate how many hooks you need to purchase. Every hook position should be in the exact middle of the board. Use a pencil to mark the placement of every hook. Make pilot openings for the relevant hook fasteners with a handheld drill at this time. Ensure that the openings are somewhat smaller in width than the screws attached to them.

Dye or Paint the Wooden Panels

It’s up to you whether you wish to paint or oil your rack. To get started, you’ll need a place to work. Wrap your dining table with newspapers or fabric sheets if you don’t own a workbench. Drop cloths can be used to shield the table’s base from damage.

Using a brush, paint the hanger in the shade and texture you choose. Make sure the paint dries for the suggested timeframe on the can box.

If you’re going to dye the rack, be sure to select an inside stain of superior quality. Using a fabric or moderate paintbrush, dab the color to the wood and leave it to settle. For a mild stain, use a single coat. Extra coats can be applied for a darker shade. Allow the item to dry properly after wiping away any remaining discoloration with a fresh cloth. Fine-grit emery cloth can be used to scrape between layers of paint carefully.

Put the Hooks in Place

With a handheld screwdriver, secure the jacket hooks to the bottom of the rack with the screws provided.

Set Up Your Hanger

You’ll want to mount your hanger on a wall. You could try to screw the hanger into wall studs; however, it may rely heavily on where you want to install it. Identify the wall studs with the use of a stud locator. If you want to be sure you know exactly where they are, use a level and a marker to note their placements. To mount the rack, all you need are long enough lines to make a trace on the wall when you place the rack on it. For each wall stud, drill a hole and insert a 2- or 3-inch wood screw.

Conclusion

Kudos! You’ve made your coat hanging out of wooden panels.